Intro

Always after reading several  posts on this forum: www.techniguitare.com. I have decided to make another classical guitar pedal effect: a rebote delay (the last release is the 2.5)

The final result:

The electronic schema and PCB design is coming ftom TonePad, here

I will describe here only the realisation.

The Parts

I ordered all the different parts to www.banzaimusic.com.

With the same PCB is possible to make two different distortion: MXR distortion + or a DOD overdrive 250.

I ordered the PCB to Etronic (my usual providerPCB provider).

Wiring in the box

For the wiring of all external parts, power, foot switch, jacks I used the 3PDT wiring proposed also by tonepad (offboard wiring 5)

Super!! I run correctly since the first try (no debug).

Intro

After my first pedal DIY (the MXR distortion) running quite well, I continue with another classical pedal effet, it’s the  Tube Screamer. For this pedal I read several post on the forum  www.techniguitare.com that describe the realisation of this pedal.

Here the final result:

The schema and the PCB design is coming from  TonePad, here Tube Screamer

I will describe only the realisation .

The parts

I ordered all the different parts to www.banzaimusic.com.

I ordered the PCB to  Etronic (my usual providerPCB provider).

Wiring in the box

For the wiring of all external parts, power, foot switch, jacks I used the 3PDT wiring proposed also by tonepad (offboard wiring 5)

Super!! It runs correctly since the first try (no debug).

Intro

After reading several post on this forum  www.techniguitare.com regarding various pedal effect DIY especially distortions. I started to make a classic  MXR distortion +

The final result:

The electronic schema and PCB design is coming ftom TonePad, this one  MXR distortion +

I will describe here only the realisation.

The Parts

I ordered all the different parts to www.banzaimusic.com.

With the same PCB is possible to make two different distortion: MXR distortion + or a DOD overdrive 250.

I ordered the PCB to Etronic (my usual providerPCB provider).

Wiring in the box

For the wiring of all external parts, power, foot switch, jacks I used the 3PDT wiring proposed also by tonepad (offboard wiring 5)

Super!! I run correctly since the first try (no debug).